blaze
New Member
Posts: 3
|
Post by blaze on Jan 11, 2014 5:01:06 GMT -8
Hi Issac, When I try to connect to SRS I get "no response from ecu" however the airbag light will blink continuously on the dash. It will continue to blink even when disconnected. It stops if I reconnect to the ABS or ECU. I can connect to the ABS and gasoline ECU, adjusting timing and rpm works fine also. Appreciate your help in getting this working. The diagram below is a pinout of the port. Thank you.
|
|
|
Post by Issac on Jan 12, 2014 10:09:41 GMT -8
Hi Issac, When I try to connect to SRS I get "no response from ecu" however the airbag light will blink continuously on the dash. It will continue to blink even when disconnected. It stops if I reconnect to the ABS or ECU. I can connect to the ABS and gasoline ECU, adjusting timing and rpm works fine also. Appreciate your help in getting this working. The diagram below is a pinout of the port. Thank you. Please enable debug log, connect to airbag few times and send log to email
|
|
blaze
New Member
Posts: 3
|
Post by blaze on Jan 13, 2014 3:37:42 GMT -8
Thank you. Log file has been emailed. Please let me know if you need anything else.
|
|
|
Post by Issac on Jan 13, 2014 16:00:23 GMT -8
Try Version 3.66.11. Please let me know if it corrected the issue. Thanks
|
|
blaze
New Member
Posts: 3
|
Post by blaze on Jan 13, 2014 17:19:07 GMT -8
Hi Issac,
Thank you for the quick response.
I updated to 3.66.11 and receiving same error as before. No response from ECU and airbag light blinking. I have emailed the new log file.
|
|